Filter Results By:
Products
Applications
Manufacturers
Improvised Explosive Device
a cobbled together makeshift bomb. AKA: IED
- TEAM SOLUTIONS, INC.
product
IEEE-488 GPIB Device Interface IC (Chip) for the PCI-Bus
GPIB-72120
The i72120 GPIB-Chip is the ideal solution to implement a IEEE488.2 GPIB interface for next generation PCI based instruments. The GPIB-ASIC is designed to meet all of the functional requirements for talker and listener (TL) devices as specified by the IEEE Standards 488.1-1987 and 488.2-1987. Connected between the PCI bus and the GPIB, this GPIB-IC provides high-level management of the GPIB to unburden the processor and to simplify both hardware and software design. The i72120 is fully compatible with the PCI specification and requires only the addition of bus driver/receiver components to implement a talker/listener GPIB interface.
-
product
System Amplifier
Solid state Broadband Amplifiers are designed for optimum operation for IED Jammer Applications which is featured as below. We can rack mount any of our existing amplifiers or systems or custom design the amplifier and enclosure. Each Rack Mounted Amplifiers are built around a large bonded fit heat-sink rated for high temperature ambient operation.
-
product
Protocol Converters
Applied Systems Engineering, Inc
ASE provides a total solution approach to the area of protocol test equipment with its’ family of PC based protocol test products. The ASE2000 RTU Test Set is a full-featured protocol test unit that provides the user with a powerful and flexible tool for testing and maintaining SCADA RTU and SCADA IED equipment and diagnosing communication problems.
-
product
Asset Management
Schweitzer Engineering Laboratories, Inc.
Asset management includes centralized management of network communications devices and IED passwords.
-
product
Universal Test Set
UTS
The Universal Test Set (UTS) is a portable, battery-powered, programmable, ruggedized radio frequency test set designed to validate improvised explosive device (IED) jamming equipment. Our unit is intended to provide an in-field confidence testing for warfighters employing IED jammers prior to departure.
-
product
Bomb Jammer
Security Intelligence Technologies, Inc.
The Bomb Jammer is a defense technology used to counter RCIED theats. It comes in several configurations. The Covert Bomb Jamming System is our trunk mountable IED Jammer. Its low profile profile antenna setup make it an ideal vehicle jammer to defeat IED threats.
-
product
Dirty Bomb Detection Jamming System
Security Intelligence Technologies, Inc.
The SSR-7000 consists of a radiation detection system that operates in concert with a MM Wave body scanner and an electronic countermeasure IED Defeat System. This three part solution is geared to deal with finding remote controlled weapons that are designed to detonate radioactive contents with a discharge that may or may not reach nuclear yield. Dirty bombs of this type are designed to cause terror and maximum panic.
-
product
High-Power Tunable Filter
CB503
The need for tunable filter technology originates from the fact that high power communication systems and IED Jammer transmitters severely limit the use of tactical radio communication systems on the battlefield.This clash within the radio’s spectrum during tactical missions is often de-conflicted using fixed high Q, high power RF bandpass and bandstop filters installed prior to mission. This can limit operational effectiveness due to the potentially large number of fixed filters required within the allocated radio communication channels, which need be transported, stored in the field, and fitted by trained personnel. Many of these fixed filters centred within the octave wide tuning range could be replaced by a single high-Q tunable filter.
-
product
Stationary Bomb Jammers
Security Intelligence Technologies, Inc.
The stationary jammer is used to combat the use of remote controlled improvised explosive devices when terrorists and criminals target a building, checkpoint, or gathering place. The stationary jammer is a bomb jammer that gives off an extended area of coverage.
-
product
Boat Mount with Pan & Tilt 2D Forward Looking Sonar
Deployed from a patrol boat, Teledyne BlueView's BV3100 is ideal for search and recovery operations, dive team situational awareness, and diver vectoring. It is also an effective means of harbor bottom inspection as well as diver and underwater IED detection.The BV3100 uses Teledyne BlueView's 2D forward looking sonar mounted to a digital pan and tilt system to deliver clear, streaming imagery during both confined and wide area searches. This real-time imagery is produced whether moving or stationary, even in zero visibility water conditions. The BV3100 can be used alone or as a complement to side scan sonar by allowing the user to reacquire and guide divers to targets found in side scan imagery.
-
product
Automation Control
Schweitzer Engineering Laboratories, Inc.
Monitoring and controlling substation power systems requires comprehensive solutions. SEL’s complete solutions and hardened devices help maintain system stability with deterministic control; streamline access to valuable IED data, communications processors, and field devices; and improve visualization and control with local HMIs and access to SCADA systems.
-
product
Roof Mounted Bomb Jammers
Security Intelligence Technologies, Inc.
The Roof Mounted Bomb Jammer series were the original IED Jammers. Our preliminary task was to design and utilize a radio jammer that would work for armored vehicle users, VIP users, and those traveling in convoys within hostile territories.
-
product
GOOSE Message Recorder
TR-61850
Whether a new or existing installation, AMETEK’s TR61850 adds the capability to easily monitor and record GOOSE messages within the substation. All data from the fault recorders and TR61850 automatically merge providing a single point of reference when analyzing transient events and system disturbances. With a wide range of time synchronization, communication options and small form factor, the TR61850 seamlessly integrates into any application.Configuration of the GOOSE Message subscriptions is quick and easy with AMETEK’s configuration tool. Using the IEC61850 Substation Configuration Language (SCL), third party IED Capability Description (ICD) files are imported and subscriptions are created by simply dragging and dropping available GOOSE message outputs.
-
product
Test Set
ASE2000
The ASE2000 Test Set is a full-featured protocol test unit. It provides the user with a powerful and flexible tool for diagnosing communication problems and testing and maintaining RTU and IED equipment. The test set has three modes of operation, Master Simulation, RTU Simulation, and Line Monitor.
-
product
Explosive Atmosphere Test
This test demonstrates that a part will not ignite while operating in an explosive ambient atmosphere. The tests are conducted at ground level pressure as well as reduced barometric pressures, in a closed explosion-proof chamber.
-
product
Explosive Atmosphere Testing
A product that is designed for or could potentially be placed in a hazardous, explosive environment must be evaluated, especially if it could cause the environment to ignite. This is imperative for products that operate within engine compartments, electrical panels that are mounted in adverse environments, pumps and much more. We can test using almost any mixture of propane or hexane gas and can support these tests with altitudes up to 50,000 ft. If you are concerned about your product’s potential risks, see us about putting your test plans in action.
-
product
DAQ Devices
LabJack makes USB/Ethernet based measurement and automation devices which provide analog inputs/outputs, digital inputs/outputs, and more.We provide a robust and highly supported interface between computers and the physical world.
-
product
Power Devices
Our power portfolio provides a wide range of low-voltage to high-voltage components featuring our advanced process and packaging technologies. These solutions meet the demands of today's most complex power system designs across the infrastructure, mobile, industrial, automotive and aerospace markets.
-
product
Control Devices
Solutions for monitoring and recording any value you wish to manage (electricity, water, gas consumption, temperatures, flow rates, pressures, units produced, etc.), either through communications or through pulse logger systems. The control system family contains the LINE solution to create a comprehensive energy management systems (SGEi), LM pulse loggers and MDC controllers to avoid surcharges in the electric bill by preventing the contracted capacity in electrical installations from being exceeded.
-
product
Device Tester
DeviceTester is an easy, fast and convenient way to test NTCIP communication between a central controller and a field device. DeviceTester is a database product that can mimic the functions of a traffic device or serve as a testing tool. The main purposes of the tool are to provide a method of testing the functionality of a new device, or aid in troubleshooting a device that is not functioning as expected. It can automatically check all device OIDs, perform automatic error simulation and create result logs and reports for your records. DeviceTester is based on a powerful database structure and includes interfaces for simple and advanced testing. All data can be exported in a variety of formats for additional custom reporting.
-
product
Proving Devices
Martindale Electric Proving Devices - safely prove the operation of voltage indicators and test lamps
-
product
Monitoring Devices
TDK Monitoring Devices - rf shielded hd video camera, rf shielded hd mini video camera, camera controller
-
product
Ferrite Devices
Ducommun's products include very broad ferrite device selections to cover 100 MHz to 110 GHz operation frequency range. These devices include narrow band drop-in (FID and FCD), connectorized (FIC and FCC), junction (FIW and FCW) isolators and circulators and iso-adapters (FII and FCI). The broad bandwidth versions are offered as full band junction isolators and circulators (FIF and FCF) and Faraday isolators (FFF). These devices feature low insertion loss, high isolation and wide operating temperature range. Low cost and volume production versions of these ferrite devices are available per customers’ request.
-
product
Medical Devices
As more medical devices become wireless, manufacturers will be looking for compact and affordable testing solutions for wireless components. Copper Mountain Technologies’ USB vector network analyzers provide portable, cost-effective network analysis solutions for medical wireless device applications.
-
product
Multi-sensor Drug & Explosive Detection System
HDK
LDS Hybrid Detection Kit (HDK) - By operating the sensors in parallel, and in real-time, results in much higher probability of detection than the performance of each specific detector. Integrated solution including laser detection technologies, dual Ion Mobility Spectroscopy (IMS) and chemical detection, that operate in synch.
-
product
Cable Locating Device
TM520
Coordinating with high-voltage signal generator, test sound and magnet simultaneously, locate high-resistance and arc-over fault of the power cable. While fixing the fault point, the instrument can test the cable path as well.Coordinating with audio-frequency signal generator, test audio frequency induction, locate low-resistance fault, and identify the cable and test the depth of it.
-
product
Optomechanical Devices
Optomechanical devices include an optical chopper, scanning galvo mirrors, adaptive optics, a motorized pinhole wheel, a piezo objective scanner, a motorized flip mount, motorized filter wheels, and optical beam shutters.
-
product
IOT Devices Testing
IoT devices refer to Internet of Things Devices. They are hardware devices programmed for specific applications and can transmit data over the internet and other networks. IoT devices include sensors, gadgets, actuators, gaming consoles, smartwatches, voice control devices, machines, vehicles, buildings, etc. collection and exchange of data.
-
product
Devices
Aegis Industrial Software Corp.
Eventually your MES system needs to interact with the physical world and that means hardware is necessary. Aegis offers pre-certified devices such as scanners as well as line control devices of its own design. The benefit for customers is a successful implementation that comes from Aegis' experience of 1600 installations dealing with thousands of identification challenges and process control challenges.
-
product
Data Acquisition Devices
Our data acquisition and encoding systems provide significant performance in reception, signal conditioning and encoding of all types of signals while used in missiles, airborne vehicles, mobile ground-based testing and other platforms that require ease of operation, flexibility, ruggedization and small packaging.
-
product
USB Device Servers
Enable printers, scanners, disk drives, cameras, card readers, and virtually any other USB device to be shared over the network so that multiple users can access the same USB device.
