Filter Results By:
Products
Applications
Manufacturers
- LBA Group, Inc
product
Static & Lighting Chokes
Lighting chokes are used to pass tower lighting voltages across the base insulator of a series-fed tower without appreciably altering the tower impedance. LBA TC-300 general purpose tower lighting chokes are provided for three wire 110/220 VAC circuits. Maximum current is 25 amps. These chokes are rated for peak base voltages to 10,000 volts, and present a typical reactance of +j5000 ohms at 530 kHz. Bypass capacitors are provided on each winding.
-
product
Anti Static Bars
Static bars, also known as, static eliminators or anti static bars, are a very cost effective way to remove static electricity on a web of material in a plastics, paper, glass, textile, and or film converting applications. All of these static bars are bi-polar ionization generators (produce both positive and negative ionization) to remove static electricity. Remember - A clean static bar is more effective.
-
product
Neon Bar Checker
9195
TAKK?s Model 9195 Neon Bar Checker offers a quick and inexpensive means of determining if static eliminator bars are functioning. The conveniently small pen size unit indicates that each bar emitter is performing properly by the activation of a neon light signal. Static eliminator bars may malfunction due to transformer defects, shorts in the system, need to be cleaned, etc. The bar tester may be used with shockless or ?hot? static control equipment.
-
product
Surface Resistance Meter
WL MIDGET
WL MIDGET Surface Resistance Meter is an ultra-wide range, battery operated, portable instrument for measuring Surface Resistivity and Resistance to Ground of virtually any flat surface conforming to ASTM D-257 standard method by using recommended parallel bar sensing probe. Gives simple, repeatable measurements of conductive, static dissipative, and insulative surfaces. Ranging is automatic due to the use of high-speed OP-AMP Integrated circuits being linear, with changeover points +1/2 decade on a logarithmic scale. Repeatability equals + 5%.
-
product
Pitot Static Test & RVSM Air Data Accs Kits
ADA320-723
Kit Model ADA320-723 (Bar type) contains the equipment required to connect the Air Data Tester to the pitot and static ports, for the performance of a complete test of the main and alternate Air Data System of the Airbus Industries A-319, A-320, A-321 aircraft. The equipment is approved by Airbus Industries.
-
product
Electrostatic Fieldmeter
FMX-004
Simco-Ion’s Model FMX-004 Electrostatic Fieldmeter is a compact handheld electrostatic fieldmeter used for locating and measuring static charges. Its pocket size makes it handy to use and four-button operation makes it easy to operate.The FMX-004 measures static voltages within ±30 kV (30,000V) at a distance of 1 inch. Results are simultaneously displayed numerically and in bar graph format.
-
product
Stationary 1D / 2D Code Readers
Leuze electronic GmbH + Co. KG
Camera-based bar code readers for stationary use: These code readers reliably capture 1D- and 2D-codes; depending on the type, printed or directly marked, omnidirectional, static or in fast motion as well as inverse or mirrored codes. Various version are available with respect to size, robustness, protection classes IP 67 or 69K, speed or high-end functions.
-
product
Spark Free Generator Bar
993R
The Meech Model 993R is a high performance generator bar for use with the Meech range of 30kV and 50kV high voltage DC static generators.
-
product
Static Generation
Fraser Anti-Static Techniques Ltd
Static generator for powering many of the electrostatic charging applications in industry.
-
product
Static Meters
ETS static meters are offer accurate detection and measurement of static electricity found in the manufacture and handling of electronic, paper, plastic, textile, food, chemical, biomedical, and pharmaceutical products. In addition, these meters are invaluable for use in computer rooms, cleanrooms, hazardous environments, hospitals, and other locations that require the measurement of electrostatic fields. Chopper-stabilized models enable measurements in ionized environments.
-
product
Static Installations
Innovative mounting solutions for maximizing the probability of intercepting Rad / Nuc sources.
-
product
Static Sensor
718
Portable Meter for Testing of Electrostatic FieldsMeasures surface voltage and polarity on objects up to ±19.99 kV at a distance of 1 inchSwitch Selectable Measurement RangesProvides readings from 0 to ±1.999 kV and 0 to ±19.99 kVChopper-Stabilized Probe TechnologyAllows for use in ionized environmentsDurable Dissipative Housing Design with Membrane SwitchesProtects meter from physical damage and minimizes wearLED Range FinderRed ranging lights help operator to place the meter at the correct distance from the object being measuredHold ButtonAllows the measurements to be retained for easy reading and extends battery life
-
product
Anti Static Nozzles
is a high-performance ionization source, designed to simultaneously neutralize static charges and remove electrostatically bonded particulate from surfaces.
-
product
Static Tester
Electrostate tester with LED indicator for the detection of static charge in the plus and minus range. An indispensable, inexpensive tool for the assessment and selection of materials in the living area, as well as the quality of the room climate.Buy Data Sheet
-
product
Pitot Static Indicator
ADSE 740
The ADSE 740 is a complete high performance dual pressure Ps and Pt standalone test bench specially designed to be used in the workshop or in the laboratory to test and calibrate all air data equipment such as altimeters, vertical speed indicators, air speed indicators, MACH-meter, air data computers ...) and sensors.
-
product
Static Measurement
Fraser Anti-Static Techniques Ltd
Accurate and versatile static measurement tools to investigate, monitor and maintain safety and productivity.
-
product
Static Inverters
Our static inverters are designed as uninterruptible power supplies (inverter in conjunction with rectifier and battery) to bridge short-term interruptions, power failures, voltage fluctuations, frequency fluctuations or generally to compensate for power disturbances in the data processing sector and in automation and control systems. They are used to supply AC consumers, primarily in the rail and industrial sectors.
-
product
Pitot Static Tester
ADSE 550
The ADSE 550 pitot static tester, housed in a plastic carrying case, is a portable, self contained field tester designed to test aircraft pilot ans static systems for leaks as well as the operation and calibration of airspeed, altimeter, engine pressure ratio, manifold pressure indicators, and other vacuum or low pressure units. The tester consists of a hand-operated vacuum pump, a hand-operated pressure pump vacuum and pressure gauges, 5 control valves, an altimeter and an airspeed indicator. The package accessories include two 25-foot hoses.
-
product
S-Beam Static Load Cells
2519 Series
The 2519-xxxN Series load cells are specifically designed for use with 3300 single column testing systems. Automatic transducer recognition and electrical calibration makes them easy to use. The load cells incorporate overload protection and can withstand loads up to 150% of their force capacity without damage and 300% without mechanical failure. The load cells allow the user to zero out the tare weight of a grip or fixture that weighs up to 40% of the force capacity, while still maintaining the full specified accuracy.
-
product
Boring Bar
After marking the leaking point on the ground, make a hole at the marked point by use of the boring bar and insert the Listening Stick into the hole to confirm the leaking point as near as possible.Fuji boring bar saves you excavation cost.
-
product
Bar Indicators
Orbit Controls bar displays are flush-mounted display devices with one or two three-color bars. They can also be ordered with a digital display. The devices are designed for connection to various process signals and can be equipped with control outputs.
-
product
Static Analysis Tool
CodeSonar
Automated static analysis designed for zero-tolerance defect environments. CodeSonar, GrammaTech''s flagship static analysis software, identifies programming bugs that can result in system crashes, memory corruption, leaks, data races, and security vulnerabilities. By analyzing both source code and binaries, CodeSonar empowers developers to eliminate the most costly and hard-to-find defects early in the application development lifecycle.
-
product
Ionization Anti Static Blower
Ionization or anti static blowers are the most versatile ionizer to control or remove static electricity from plastic, paper, glass and other non conductive materials. This static control blower offers the ability to cover a large area cost effectively. This static control equipment is an excellent choice to reduce static electricity and reduce operator static shocks and production applications needing large area coverage.
-
product
Static Remover (Ionizer)
STABLO-AP
STABLO-AP provides reliable measurement by removing static electricity.
-
product
PITOT STATIC TESTER
ADSE 745
The ADSE 745 caters fully for all aircraft types and the different electrical power supplies.It can be used for testing high performance civil and military aircraft, fix and rotary wing. The multi-pressure outlets option can suit the more complex pilot-static-systems. This Pitot Static Tester is designed primarily for flightline use to cover the testing of all barometric and manometric pressure instrument systems.
-
product
Self-testing Static Grounding Clamp
Bond-Rite CLAMP
In many branches of the process industries, fires and explosions can result from electrostatic discharge in hazardous areas. Even relatively small sparks have sufficient energy to ignite many flammable vapours, gases and even airborne dusts. In situations, where this risk exists, static grounding (earthing) and bonding clamps are required wherever mobile or portable conductive plant items (such as drums and vessels etc) are used.
-
product
Static Grounding for Process Plant & Equipment
Earth-Rite OMEGA II
The Earth-Rite OMEGA II monitors the resistance of the static grounding circuit for processes where a risk of static charge accumulation on the equipment could result in an incendive electrostatic spark within locations that have potentially flammable atmospheres present.
-
product
Static Tester
DRK151
Shandong Drick Instruments Co., Ltd.
The tester is applicable in testing the surface potential and the properties of anti-static products .This tester applies to test electrostatic voltage of charged object such as conductor, insulator, and the human body.
-
product
IML Static Generator
994 IML
The 994-IML Static Generator has been designed after consultation with "In Mould Labelling" OEM's. The criteria they laid down was that the unit needed to be compact, light & reasonably priced.
-
product
Color Bar Generator
BL-CBG402-01N
The BL-CBG402 is a small (2 inch x 2 inch) RGBS Color Bar Generator designed for embedded and systems applications. It produces a split field SMPTE style color bar pattern and has either an external composite sync line of optional sync-on-green (set with an optional on-board DIP switch) Video timing is NTSC/EIA 60Hz field rate. The BL-SBG402 operates from a +5V regulated power source.
-
product
Portable Bar Code Verifier
Inspector 5000 Auto Optic
The Inspector 5000 Auto Optic provides ISO 15416 and ANSI X3.182 Method. This unique portable bar code verifier can interface with either the patented RJS Auto-Optic scan head or a laser scanner. Store and print capability, multiple scan averaging and subsymbology choices are easily accessed through a simple seven-button user interface with a large color LCD display. The scanners are easily installed by the user, which makes the unit quickly adaptable to practically any verification requirement.
